Geeetech RAMPS-FD Controller Mainboard For Arduino Due Reprap 3D Printer

Spedizione da magazzino Europeo

nessuna tassa doganale è richiesta per le spedizioni nel mercato UE

Country:

Metodo di spedizione: Italy

Magazzino : Italy

Italy: Metodo di spedizione
Shipping Direct mail 1-3 weeks (Tracked) EUR 4,50

Cod.: BG-1080993

€36,11

Metodo di spedizione

Quantità:

i h

Feature:

When you use Arduino Due as the controller of your 3D Printer, you may find the RAMPS1.4 is not compatible with DUE. As you know the Arduino Due is a microcontroller board based on the Atmel-SAM3X8E ARM Cortex-M3, the importance is the Atmel-SAM3X8E chip used on the Due operates at 3.3V, worse applying 5V to the Due's inputs will likely damage the chip.
So we create a new RAMPS variant which is compatible with the Due to replace Ramps1.4.

Why should I use Ramps-FD instead of Ramps1.4?
Campare Ramps-FD with Ramps1.4, the improvements of Ramps-FD are below:
* The RAMPS-FD has other hardware protection, through the jumper cap control motor drive IC
* The RAMPS-FD Much more than Ramps1.4 2-way PWM
* The RAMPS-FD has Larger driving power than Ramps1.4
* The RAMPS-FD power has two choices: 12V and 24V

Why should I select Arduino DUE instead of Arduino Mega?
* CPU operates at 3.3V
* High-current IO pins are capable of 15 mA source, 9 mA sink
* Low-current IO pins capable of 3 mA source, 6 mA sink
* CPU package has an absolute max of 130mA
* The Due has 1 dedicated SPI port, and 4 multipurpose USART/SPI ports. The SPI port is only routed to the 6 pin header used for ICSP on Mega, but this is not used for ICSP on Due
* The Due does not have any EEPROM
* Due has lower power, computing faster and flash, sram bigger than mega2560.

You will need to buy a LCD adapter for RAMPS-FD.

Package included:

1 x RAMPS-FD Shield for Arduino DUE

Etichetta del prodotto